Folks new to the RVing lifestyle have to learn new things: How to flush an RV toilet. How to keep the RV refrigerator really cold. And that slideout? "Is it possible to slide my slideout too far?" It's a valid question, and one we'd like to touch on, along with some other slideout tips.
First, no, it's not really possible to slide the slideout too far. Most manufacturers simply say to push the slideout button and hold it until the slideout is fully extended. With a gear-driven slide mechanism, you'll likely hear a "Clunk! Clunk! Clunk!" noise when you've racked out far enough. A hydraulic system may give off a little whining noise.
But before you hit the slideout button, make sure you have sufficient clearance--both to the side and up above (you'd be surprised how much damage a low hanging limb can do). Also ensure that your rig is leveled--slideouts can bind or pinch in some circumstances.
Here's some other tips that can make your slideout a happy camper:
When opening or closing a slideout room, check the floor. Sand, grit, or other "foreign" substances can get under the slideout and scratch the flooring. Doesn't make Mama happy, and if she ain't happy--well, you know the rest. Likewise, before retracting the slideout, check up topside. Branches, leaves, bird nests, all manner of odd things can wind up on the outside of your slideout, even if you have a retracting slideout awning. If this "junk" gets trapped in the retraction process, you can be in a world of hurt.
In terms of periodic maintenance, seals certainly need to be looked after. Seals can dry out, leaving you without protection from the elements. What does your manufacturer recommend? There are some commercial nostrums available, but we'd suggest you be careful of something that contains silicone. We've been on this lectern before, silicone can dry rubber out.
What about the slide mechanism? Here's where things can get contrary. Nearly everyone agrees that slides should be lubricated regularly, it's just what lube to use is where it gets dicey. One prominent RV technician says you should never use a "wet" lube like WD-40. He feels that the lube may well attract dust and dirt to the mechanism. Others suggest using silicon sprays. Ach! Again, what's your manufacturer recommend? If you're under warranty, best to use what they call for in case you develop a problem that they'll need to fix.
Hydraulic reservoirs should be checked regularly. If they're low, you'll need to find out why. Is there a system leak? Follow the lines from the hydraulic fluid reservoir through the pump, and out to the actuating cylinders. If you need to 'filler'up' then again, be sure to use what the factory calls for. Some slideouts call for transmission fluid, others specialty hydraulic fluids. Know what you need before you pour!
Finally, this golden rule applies to ALL types of slideouts. KEEP THE BATTERY CHARGED! There's nothing more difficult than being in the middle of nowhere and having that slide refuse to go back in because your battery is low or kaput. Cranking that slideout back in by hand is a long, and slow process.
All
original content copyright 2012 by RVbookstore.com
PRIVACY STATEMENT: We never sell or share any information about our readers
or customers with any outside party. CONTACT US
